Clarke Power Wash PLS190, Operation & Maintenance Instructions Manual

Page: 18 / 28

18
STORAGE
ENGINE
See the separate engine manual supplied for information regarding the storage
procedure.
PUMP
1. Drain all water from the high pressure hose, coil it and store it on the gun/
hose holder located on the side of the power washer handle.
2. Drain all water from the spray gun and spray wand by holding the gun/
wand vertically with the nozzle pointing down and pulling the trigger. Store
in the gun/hose holder.
3. Store all other parts so that they are protected from damage.
STORAGE PROCEDURE
For long term storage, the petrol tank should be drained. Ensure that the
engine is cold before draining the tank. Remove the fuel tank cap and use a
pump type syphon to drain the petrol into an appropriate, clean container.
Do not store petrol for long periods of time.
Dispose of excess petrol in an environmentally safe way. Your local recycling
centre can advise you on the best method of disposal. After the petrol tank
has been drained, start the engine and allow it to use any petrol that may
remain in the engine, or fuel pipe. Make sure that the power washer has been
thoroughly cleaned before storing it in a clean dry place.