17
CLEANING THE NOZZLE
If the nozzle becomes clogged with foreign materials such as dirt, excessive
pressure may develop. If the nozzle becomes partially clogged or restricted, the
pump pressure will pulsate, clean the nozzle immediately by follow the below
Instructions:
1. Shut off the power washer and turn off the water supply.
2. Pull trigger on gun handle to relieve any water pressure.
3. Disconnect the spray wand from the gun.
4. Remove any obstructions with the nozzle cleaning tool provided and back
flush with clean water.
5. Direct water supply into spray wand end for 30 seconds to back flush
loosened particles.
6. Reconnect spray wand to gun and turn on water supply.
CLEANING THE WATER INLET FILTER
This screen filter should be checked periodically and cleaned if necessary.
1. Remove filter from the water inlet
of the pump as shown.
2. Clean filter by flushing both sides
with water.
3. Replace the filter into the water
inlet.
• Cone side faces out.
NOTE:
Do not operate power
washer without filter properly
installed.
Summary of Contents for Power Wash PLS190
