ASSEMBLY AND PREPARATION FOR USE
A 3/4” BSP adapter with a 1/2” hose
connector is provided at the low
pressure water inlet, shown at B, Fig.3.
Screw it on to the water inlet, ensuring
the plastic washer provided is inserted.
A suitable hose with a MINIMUM inside
diameter of 1/2” (not supplied), may be
attached, with a worm drive clip (not
supplied), and connected to your
water supply. Alternatively, quick fit
couplings, which are readily available
from most hardware or DIY stores, may
be used.
Turn on the water supply, and check
for leaks. Rectify if necessary.
Firstly assemble the hose bracket to the frame using the 4 screws and nuts provided.
CAUTION.
The water inlet connection is directly above the diesel fuel filler cap. Ensure the
connection is completely leak free, otherwise there is a possibility of fuel
contamination should the filler cap be inadvertantly loose, or dislodged.
Water Supply
The Lance
2.
Remove the travel plug from the outlet
port, at the front of the machine (A
Fig.2), and screw on the high pressure
hose, then connect the other end to
the lance (Fig.2A).
1.
The lance is assembled
by screwing the two sections together.
Fig.1.
Fig.3.
Fig.2.
Fig.2A.
7
Tighten the
connections,
but take care not
to overtighten.
Finally, slide the
shroud up, and
over the screw
connection on
the lance, firmly.
PARTS DIAGRAM
14
