4
.
Car
efully tur
n the chassis onto one side to access the
axle to enable wheel to be fitted. Slide wheel onto
axle as shown, ensuring the flat side is on the inside as
in
Fig. 2
to allow the cap to be fitted.
Fig. 2
5
.
Place the wheel securing washer in the drift as shown,
ensuring the concave side faces outwards.
6
.
Position the washer centrally on the axle, gently
using a suitable hammer/mallet, drive the washer
onto the axle as in
Fig. 4
. T
ake care not to drive it
on too far
, allow a slight sideways movement of
the wheel.
7
.
Repeat 4, 5 & 6 for other wheel.
8
.
Fit the wheel caps by lining up the securing lugs
on the inner flange and gently tap on by hand.
9
.
Tu
rn
the chassis over onto its wheels and feet.
Fig. 3
Fig. 4
Fig. 5
1
0
.
Fit the lower tool holder to the frame by locating the
holder lug into the smaller L/H slot on the bracket,
rotate the holder until the R/H lug locks into position.
Fig. 6
12.
Slide the upper tool holder up into position and secure with
self tapping scr
ew.
Fig. 7
1
3
.
Assemble the lance to the gun with
a simple bayonet connection
Fig .8
. Attach one end of the high
p
ressure hose to the gun
Fig. 8a
and tighten the securing nut using
a 17mm open ended spanner
, DO NOT overtighten. Connect
other end of the high pressure hose to the pump Fig .8b,
hand tight only.
Fig. 8
Fig. 8a
Fig. 8b
14.
Refer to the engine manufactur
ers handbook regar
ding topping up oil and fuel. Once
the oil and fuel levels are OK, the pr
essure washer is ready for use.
OPERA
TION.
NOTE:
before connecting the garden hose, unscrew and remove the hose connector which
is located on the opposite side of the pump to the high pr
essure hose connector
Fig.
8b
,
c
heck that the water filter is in place and is not damaged.
1
.
Connect the gar
den hose to the water inlet (hand tight only).
2
.
Connect the other end of the gar
den hose to the mains water supply and tur
n
ON.
3
.
Depress the gun trigger to clear any trapped air
, keep depressed until a steady flow
of water emer
ges fr
om the spray nozzle.
4
.
Refer to engine handbook on starting the engine.
Move the thr
ottle control lever to the run position.
Fig. 9
5
.
Slowly press the primer ball 3 times, waiting 3 seconds
between each press. In cold weather conditions, press
the ball 5 times.
-5-
-6-
Detergent Hose
11.
Slide the upper tool holder onto the chassis above the
lower holder
. Fit the handle by lowering onto chassis as
far as the locking pins, depr
ess pins and lower further
until the pins click into position.
NOTE:
take car
e not to pinch fingers in the mechanism when
carrying out this action.
Fig. 9a
