7
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
BEFORE USE
CHECKING THE OIL
1. Remove the cover from the
pressure washer by removing the
securing thumbscrew from the
front and then the rear of the
cover then lifting it off.
2. Turn the oil filler cap anticlockwise
to remove it from the pump and
wipe the integral dipstick with a
clean cloth.
3. Insert the oil filler cap fully back
into place and then remove it
again.
4. If the oil is near the low mark on
the dipstick, add oil to the oil
reservoir.
• Do not overfill the oil reservoir.
• We recommend the use of
SAE30 oil.
• Do not mix grades of oil as this may effect the machine’s performance.
WARNING: TO CARRY OUT THIS CHECK, PLACE THE PRESSURE WASHER ON
LEVEL GROUND WHILE SWITCHED OFF.
WARNING: TAKE CARE NOT TO TOUCH ANY HOT PARTS WHEN CHECKING
THE OIL LEVEL.
Summary of Contents for HLS130
Page 32: ......
