Clarke CPSB200, Operation & Maintenance Instructions Manual

Page: 13 / 20

13
CLEANING/REPLACING
1.
Fig 18
Press the release catch and
unscrew the condensation
chamber, see Fig 18.
2.
Fig 19
Unscrew the filter as shown in Fig
19 and wipe clean.
NOTE: Do not use harsh or abrasive
chemicals when cleaning
the condensation chamber.
3. Refit the condensation chamber.
REPLACING THE NOZZLE
NOTE: ONLY use identical replacement parts when servicing.
After l0-l2 hours of blasting time the nozzle should be checked for wear. The
nozzle will wear out over time and should be replaced when the hole is no
longer round or the abrasive media does not flow smoothly through. To
replace the nozzle:
1. Disconnect the sandblasting gun from the air hose.
2. Unscrew the nozzle adaptor, located at the front of the sandblasting gun.
3. Remove the old nozzle.
4. lnsert a new nozzle.
• A pack of replacement nozzles are available from your Clarke
dealer Part number 7640132.
5. Replace the nozzle adaptor and firmly screw it onto sandblasting gun.