8
BEFORE USE
INSTALLING AND CHANGING ROUTER BITS
1. Rotate spindle whilst pushing the
spindle lock inwards until spindle is
locked, (hold the spindle lock on).
2. Using the wrench supplied, loosen
the collet nut a few turns and
remove bit if fitted.
3. Insert new bit and tighten collet
nut, release spindle lock.
IMPORTANT: At least two thirds of the
bit shank should be located inside the collet.
FITTING THE DUST EXTRACTION COVER
1. Fit the dust extraction cover to the
router as shown.
2. Use the screws provided to secure
the dust extraction cover.
WARNING: MAKE SURE THAT THE ROUTER IS SWITCHED OFF AND
UNPLUGGED FROM THE MAINS SUPPLY BEFORE FITTING OR REMOVING
ANY ACCESSORIES.
WARNING: NEVER TIGHTEN THE COLLET NUT WITHOUT A ROUTER BIT
INSERTED
Summary of Contents for CONTRACTOR 6462072
Page 19: ...19 DECLARATION OF CONFORMITY ...
Page 20: ......
