background image

 

 

 

 

 

BEXT 100H Extractor 

Operation and Safety 

 

Safety Practices: 

 
Machine can cause an 
explosion when operated 
near flammable material 
and vapors.  Do not use 
this machine with or near 
fuels, grain dust, solvents, 
thinners or other 
flammable materials. 
 
Always use a 3- wire 
electrical system 
connected to the electrical 
ground. 
 
Keep hands, feet, and 
loose clothing away from 
all moving parts on the 
machine. 
 
Remove the electrical plug 
from the electrical outlet 
before doing any repairs or 
maintenance to this 
machine. 
 
Never leave the machine 
unattended while it is 
connected to a power 
source. 
 
It is recommended that 
you use liquid cleaning 
chemicals.  Powder can 
damage the machine. 
 
Do not use water that is 
hotter than 120°F (40° C). 

 
 

www.clarkeus.com/rental 

 
 
 
 

 
More on reverse…. 

 

Application:

  Easily extract large or confined carpeted areas such as 

stairs or tight office spaces.  Use optional hand tool when cleaning 
partition, fabrics and upholstery. 
 

Set-up and operation 

Follow the steps below to successfully use extractor: 
 

Step Action 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

To set-up machine: 

a.)  Connect vacuum hose to the 

hose connector on the 
extractor (1) and to the end of 
the vacuum tube on the floor 
tool (2). 

b.)  Connect the solution hose (3) 

to the extractor and the floor 
tool (4). 

c.)  Put clean hot water into the 

solution tank (5). 

d.)  Add a cleaning chemical to the 

hot water (for amount see 
container). 

e.)  Plug in cord #1 (identified by 

red “H” on the end). 

f.)  Turn pump on (6) and set the 

switch to “Upholstery” setting.  
Run till pump is fully primed 
and then turn off pump. 

g.)  Remove the priming hose and 

attach the cleaning hose & tool. 

h.)  Turn on the pump and spray 

through the cleaning tool for a 
few seconds to fill line with 
solution. 

i.)  Plug in cord #2.  The “locator 

light” (7) will light up when the 
cords are plugged into 
separate circuits. 

j.)  Turn “heat” switch on and wait 

2 minutes to reach operating 
temperature. 

k.)  Begin cleaning (see steps 2 

and 3). 

 
NOTE:  The “mode” light will turn 
on when the heat exchanger is 
actively heating. 
 
NOTE: If the “locator” light does not 
light when cord #2 is plugged in, try 
another outlet until it does come on. 

 

 

 
 
 

 

Reviews: