8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
CONNECTING THE MAINS WATER SUPPLY
NOTE:
Always follow the regulations of your local water supplier.
1. Screw the inlet adaptor to the
water inlet as shown.
2. Connect the supply hose to the
inlet adaptor.
• A standard garden hose or a
reinforced hose with an inner
diameter of at least 10 mm
available from your CLARKE
dealer will be suitable.
3. Connect the supply hose to the
water supply.
• The water supply must provide a minimum of 7 litres per minute at a
maximum of 40°C.
4. Open the water tap fully.
OPERATION
1. Turn the water supply on, making sure that the tap is fully open.
2. Plug the mains power cable into
the electricity supply.
3. Set the switch to the ON position.
WARNING: FAILURE TO TURN ON THE WATER FULLY COULD CAUSE
DAMAGE TO THE POWER WASHER INTERNAL COMPONENTS.
WARNING: DO NOT USE THE POWER WASHER IF THE SUPPLY CABLE OR
IMPORTANT PARTS OF THE MACHINE ARE DAMAGED, E.G. SAFETY
DEVICES, HIGH PRESSURE HOSES, TRIGGER.
WARNING: WE RECOMMEND THAT THIS MACHINE IS CONNECTED TO THE
MAINS SUPPLY VIA A RESIDUAL CURRENT DEVICE (RCD).
Summary of Contents for 7333520
Page 16: ......
