EN
ENGLISH
Clarke
®
American Sanders
Operator's Manual (EN) - American B2
FORM NO. 70896A - 7 -
Figure 3
Figure 4
HOW TO PREPARE THE MACHINE FOR OPERATION
How to Install the Sandpaper
NOTE
: Use a sandpaper disc that has a 7" diameter and
a
7
/
8
hole in the center.
1. Put the machine upside down.
2. A special wrench is in the bracket behind the
motor. Use the special wrench to remove the
screw and washer from the center of the sanding
pad. See Figure 3.
3. Put the sanding disc in position on the sanding
pad.
4. Put the special washer and the holding screw in
position in the center of the sanding pad.
5. Put one hand on the sandpaper. Using the special
wrench, turn the screw clockwise with the other
hand. Make sure the screw is tight. See Figure 4.
6. Return machine to upright position.
WARNING:
Serious injury could occur when at-
tempting to replace abrasive while
machine is connected to power supply.
Always disconnect power before
installing abrasive.
CAUTION:
Gearbox damage could result from
machine resting upside down for
extended periods of time. Lubricant
may drain from gearbox. Always return
machine to upright position after
installing abrasive.
