Clark OSQ 126, Operator'S Manual

Page: 54 / 100

4.2
Operating Your Vehicle
Starting the Vehicle:
1. Attach your safety harness to
the tether, if equipped (NOT
SHOWN).
2. Lower the control arms and safety
gates.
3. Depress the foot switch (A).
4. Insert the key (B) and turn to the
ON position.
5. Pull up on the emergency stop
switch (C).
6. Apply the travel switch (D).
Before Operating:
• Visually inspect the entire vehicle for any obvious damage.
• Check that the safety lights and horn, function properly.
• Check for proper service brake operation.
• Remove the wheel chocks, if installed.
• Connect the battery connector.
Beginning Operation
IMPORTANT!
CLARK recommends operating the vehicle under light load conditions
for the first 100 hours of operation.
• Avoid sudden stops, starts, or turns.
•
Check initial fluid change intervals (located in this manual).
• Limit loads to approximately 75% of rated loads.
•
Do not allow battery to drop below 20% remaining charge.
• Perform all preventative maintenance services as required.
A
B
C
D