Clarion VRX928RVD, Service Manual

Page: 4 / 44

- 4 -
VRX928RVD
NOTES OF ISO CONNECTOR
1. For VW and Audi vehicles,change the position of fuse
installation as shown on the diagram.(Figure 1)
For models 1992 and later
For models up to 1991
Figure 1
2. When the car stereo is installed in 1998 and later
Volkswagen models,make sure to cut the car lead wire
connected the A-5 terminal.(a breakdown could occur if
the lead wire is not cut.)After cutting the lead wire,insulate
the front end of the lead wire with insulation tape to pre-
vent the risk of short-circuits.(Figure 2)
Note: Before cutting the lead wire,disconnect the car
battery - (negative)cable.
Figure 2
3. When Main unit is also connected to an external
amplifier,connect REMOTE on the external amplifier to
the previously cut lead wire on the side of the connector
4. When an extension lead is required in the extension cable
type wiring procedure,disconnect the auto antenna
leads(BLU/WHT).Be sure to insulate both the ISO con-
nector side terminal and the main unit side terminal with
insulation tape,respectively.(Figure 3)
Figure 3
BLOCK DIAGRAM
DVD mechanism section
15A
FUSE
YEL
BLU/WHT
RED
Initial setting of extension lead
YEL
RED
RED
YEL
YEL
RED
RED
YEL
YEL
Insulation tape
Insulate the terminal
Never let the terminals make contact
with the metal plate parts of the car.
*
BLU/WHT
BLU/WHT
BLU/WHT