Tap it to receive a warning when approaching a road safety camera or
other Alert Points like school zones or railroad crossings. You must
make sure that using this feature is legal in the country where you
intend to use it.
You can set the warning type for the different Alert Point categories
(alert types) individually. The following warning types are available:
•
Visual warning: the type of the Alert Point, its distance, and the
related speed limit appear on the Navigation view while you are
approaching one of these locations.
•
Audio and Visual warning: besides the visual alert, beeps are
played (when using a natural voice) or the type of the alert is
announced (in case of a TTS voice) while you are approaching
one of these points, and an extra alert warns you if you exceed
the given speed limit while approaching.
For some of the Alert Points, the enforced or expected speed limit is
available. For these points, the audio alert can be different if you are
below or above the given speed limit.
•
Only when speeding: The audio warning is only played when you
exceed the given speed limit.
•
When approaching: The audio warning is always played when
approaching one of these Alert Points. In order to draw your
attention, the audio alert is different when you exceed the speed
limit.
Maps may contain driver alert information that can be shown on the
Navigation view in a similar way as real-life road signs. Tap it to enable
or disable the warning for these road segments (for example, dangers
and sharp curves). For each category of warning signs, set the warning
type (visual or audio and visual) and the distance from the hazard to
receive the warning at.
4.3.4 Navigation View settings
These settings allow you to fine-tune the appearance of the Navigation view. You can also
adjust how the software helps you navigate with different kinds of route-related information on
the Navigation view.
Tap
to adjust the navigation view to your needs, choose suitable colour
themes from the list for both daytime and nighttime use, show or hide 3D buildings,
landmarks, and manage your Place visibility sets (which Places to show on the map).
You can modify the following settings:
76 NX405E English
