IN
STALL
G
U I D E
I
The CS-WRP-10
is a battery backed up device that
extends the wireless range of Clare compatible sensors.
Features
• Extends the range of Clare wireless sensors
• Rechargeable Backup Battery
• Cover and Wall Tamper
• 5-Year Warranty
Enroll
the repeater itself by placing the panel into
wireless enrollment mode and then tampering the
repeater. Alternatively, the repeater can be enrolled
using the Install Assist App.
Install
by mounting the repeater in the desired location
using the mounting screw holes. Then connect the
power supply to the repeater.
Set the repeater protocol
by changing both the
panel and sensor selection knobs to position 8 ().
Note:
This repeater is for devices only. Other
sensors and protocols are not supported.
Wall mounting
screw holes
Use two #4 or # 6 screws for mounting (not included)
Wall Tamper Screw Hole
(Do not over-tighten screw)
Enable configuration mode
by pressing and releasing the “
Configure”
button. The
repeater will beep and the yellow LED will illuminate to confirm configuration mode is
enabled.
Configuration Mode Tips
• Configuration mode ends automatically when the cover is closed, the
“
Configure”
button is pressed again, or 30 minutes after the last action.
• Configuration mode is locked out 24 hours after power up. To re-enter
configure mode, the repeater must be power cycled by removing both the
12VDV input power and backup battery for at least 5 seconds.
• When re-entering configuration mode, previously learned sensors are
retained.
Learn Sensors
to be repeated by placing the repeater into configuration mode and
tripping the desired sensors.
• When repeating life safety devices, two repeaters MUST BE used in parallel.
• The repeater will beep after learning each new sensor.
• Sensors not learned into the repeater
will not
be repeated.
Use the panel installation guide to verify proper system setup.
CS-WRP-10
Wireless Range Repeater