clage 3200-36450, Operating And Installation Instructions

Page: 47 / 314

47
EN
CLAGE
• The electrical power supply cable may be connected in the upper part or is surface
mounted. Only in such case, first follow the steps one through three according to
the description “Electrical connection from above” in chapter “Electrical connec-
tion”.
1. Place the appliance on the heater bracket so that the threaded rod of the wall
bracket fits in the corresponding hole of the appliance. If necessary, slight cor-
rections are possible by carefully bending the threaded rod of the wall bracket.
However, it must be possible to screw on the water connection pipes of the appli-
ance without applying force.
2. Screw the plastic knurled nut onto the threaded rod of the wall bracket.
3. Screw the two ⅜ inch union nuts of the appliance‘s water connection pipes, each
with the ⅜ inch seal, onto the fittings.
5. Installation
Installing the appliance
(a)
closed
open
4. Open the water supply line to the unit and slowly open (position “open“) the shut-
off valve (a) in the cold water connection piece. Check all connections for leaks.
5. Next, open and close the hot water tapping valve several times until no more air
emerges from the line and all air has been eliminated from the instantaneous water
heater.