clage 3200-36450, Operating And Installation Instructions

Page: 31 / 314

31
EN
CLAGE
Main menu
Press the menu button to enter the main menu. All function menus and saved values of
the appliance can be selected from here.
ECO
ECO mode: When this mode is activated and the unit is operating in an energy-
efficient range, this is indicated by the ECO symbol.
Maximum temperature reached: The temperature cannot be increased any fur-
ther since the set temperature limit has been reached. The temperature limit
can be changed in the main menu via “Settings”.
Heating activated: As soon as the appliance heats water, this symbol appears.
Power limit: The full output of the instantaneous water heater does not suffice
to heat the tapped quantity of water to desired temperature. Reduce the quan-
tity of warm water at the tap.
2. How to use
Automatic
In this menu, two functions can be selected. Automatic either measures the time in
seconds via the function “Duration” or the flow of heated water in litres via the func-
tion “Fill-Up”. Cold water added at the tap cannot be recorded by the appliance. In
order to use the Automatic function correctly according to the fill quantity, it is there-
fore necessary to set the desired temperature and only turn on the hot water tap.
For each function per user profile, the last set start value is saved and can be activated
at any time.
Note: In Automatic mode, the operating functions are limited. When selecting a lim-
ited function, an instruction window appears. Select “OK” to deactivate Automatic
mode and all functions are freely available again. Tap on “Cancel” to close the instruc-
tion window and Automatic mode remains active.
Duration:
Under “Duration”, set the desired time and then select “ Start ” to activate
Automatic mode. The view changes to the main control where the set time is displayed
to the right of the temperature display.
Turn on the hot water tap to start the function and the time starts to count down as
seconds. Turning off the tap does not pause the function. If hot water is already flow-
ing whilst the function is activated, it starts immediately.
To cancel the function, tap on menu button and confirm the message with “ OK ”.
When the time has elapsed, a message appears. In addition, the flow quantity, if it is
being drawn, is reduced for around 10 seconds and then increased again.
Fill-Up: Under “Fill-Up” set the desired water quantity and then select “Start” to acti-
vate Automatic mode. The view changes to the main control where the set quantity is
displayed to the right of the temperature display. Turning on the hot water tap starts
the function and the set fill quantity counts down in litre increments according to the
flow measurement.
Continued turning off and on of the tap pauses and restarts the function. If hot water
is already flowing whilst the function is activated, it starts immediately. To cancel the
function, tap on menu button and confirm the message with “ OK ” or turn off the
water flow for a minute.
When the fill quantity is reached, a message appears on the display and the appliance
stops the water flow by closing the motor valve. The motor valve stay closed until the
message is confirmed at the appliance, remote control or via app.
Turning off the tap is always necessary, the function must therefore not be used unsu-
pervised.
Before using the bath, make sure that the water temperature is what you want it to be.
Hint: The water amount of the last draw-off is stored in the “Statistics” menu. To
determine the necessary amount of water for your bathtub, fill it with warm water,
then select “Statistics” in the main menu and read out the value of this last drawing.
Enter this value in the automatic function “Fill-Up” to use it for the next bathtub filling.