475 BARELL AVE, CARLSTADT, NJ 07072
800/230/9497 201/549/1160 201/549/1161 FAX
© City Theatrical 20
22
FEATURES & COMPONENT IDENTIFICATION
ALPHA/NUMERIC DISPLAY
USER CONTROLS
CHs 1-4 OUTPUT
TERMINALS
COMMON (V+) OUTPUT TERMINAL
DC+ INPUT
TERMINAL DC- INPUT
TERMINAL
DMX INPUT/OUTPUT
TERMINAL BLOCK
1. Connect the QolorFLEX™ 4x5A DINrail Dimmer to your DMX controller using the D1+, D1-, and Ground terminals on
the DMX input/output terminal block. As needed, DMX out connections can be made using the D2+, D2-, and Ground
terminals.
2. Connect your load to the output channel spring terminals. For single color LED tape with two connection wires, connect
the V- (black) wire to any one of the four output channel terminals and the V+ (red) wire to its corresponding terminal.
When using multi-color LED Tape, connect as follows: CH1-red, CH2 -green, CH3 -blue, and CH4 -fourth color.
Note*-
The V+
(common) circuit for multicolor tape will be connected to either a black or white wire.
To determine which
is
correct, look at one of the sets of contacts on the tape itself and note which color wire is connected to the one
labeled (+).
Do not exceed
the maximum load capacity of
5
A per channel.
3. Connect the appropriate power supply providing 12-24VDC to the power input spring terminals.
Note*-The size of the
power supply must match the tape being used in both voltage and watts.
QolorFLEX™ 4x5A DINrail Dimmer's
maximum output power
rating is: 240W (12V),
and
480W(24V)
.
Revision 1.
3
The QolorFLEX 4x5A DINrail Dimmer can control a full
20A of LED tape spread over four channels of 5A
each. It uses constant voltage technology which
ensures consistent full range dimming that is especially
important at low end light levels. The unit mounts to a
standard hat section DINrail, and has terminal blocks
for all electrical and data connections.
An easy to read onboard display and four button user
interface allow selection of
Modes,
DMX addresses,
setting quantity of DMX channels, selecting 8 or 16 bit
output resolution, setting PWM frequency (500Hz to
30KHz), setting output dimming curve values for
matching the
dimming curves of other dimmers in use,
Quick Start Instructions:
and setting the device’s operating profile.
The
QolorFLEX 4x5A DINrail Dimmer is also
RDM
capable.
Both DMX and Standalone Modes are
available depending on your application.
The unit
requires a separate power supply providing input
voltage of 12-24VDC. The maximum current load per
channel is 5A with a maximum device output of 20A.
The
QolorFLEX
4x5A DINrail Dimmer
operates
perfectly with City Theatrical’s QolorFLEX LED tape,
the LED tape of professionals on Broadway, network
television, and architectural lighting installations.
QolorFLEX
®
4x5A
DINrail
Dimmer
P/N 582
5
Quick Start Guide
Mode
- Sets the Mode to either DMX (Run 1) or
Standalone (Run 2).
