![Citrix ByteMobile T1010 Installation, Configuration And Administration Download Page 81](http://html1.mh-extra.com/html/citrix/bytemobile-t1010/bytemobile-t1010_installation-configuration-and-administration_2611003081.webp)
T-Series Traffic Director Installation, Configuration and Administration Guide
3-7
Assigning VLANs, IP Addresses, and Ports
•
Egress VLANs:
–
VLAN ID 200 is the OSN egress VLAN. It is configured on the T1000 ports as well
as all OSN internal ports.
–
VLAN ID 251 is the T1000 egress VLANs. It is configured on the T1000 ports and
on the Internet-side router.
•
Management and Other VLANs (not shown in Figure 3-2):
–
VLAN ID 130 is for T1000 management and high availability purposes.
–
VLAN ID 66 is for internal communication between OSN and CSM blades.
–
VLAN ID 131 is for OAM connectivity to the operator management network.
Interface (Port) Assignments and Trunking
The T1000 uses an
interface
/
index
method for specifying ports. The two management ports
are referenced as Interface 0/1 and Interface 0/2
1
. The data plane ports are referenced as
follows:
•
T1010: Interface 1/1 to 1/6 (Ethernet) and 1/7 to 1/12 (1GE SFP)
•
T1010 (8-Port):Interface 10/1 to Interface 10/8 (10GE SFP+)
•
T1100 (16-Port): Interface 10/1 to Interface 10/16 (10GE SFP+)
•
T1200: Interface 1/1 to 1/12 (1GE SFP) and 10/1 to 10/24 (10GE SFP+)
The examples in this chapter use the following interface (port) assignments:
•
Interface 10/1 and 10/2 will be reserved for communication with the Unison blade
switch.
•
Interface 10/3 will be reserved for ingress VLAN 151.
•
Interface 10/4 will be reserved for egress VLAN 251.
T1000 ports support the link aggregation control protocol (LACP) for trunking. In this
example, Interface 10/1 and 10/2 will be trunked to the blade switch. After LACP
configuration these trunked ports will be referenced as Interface LA/1.
Additional trunks may be added on any T1000 interface to increase throughput capacity.
Note:
If using the T1010 (which has only 1GE interfaces), substitute the appropriate
interfaces as appropriate. For example, use interface 1/7 instead of 10/1.
1. The T1010 has only one management port, referenced as Interface 0/1.
Summary of Contents for ByteMobile T1010
Page 10: ...x T Series Traffic Director Installation Configuration and Administration Guide...
Page 14: ...Contents xiv T Series Traffic Director Installation Configuration and Administration Guide...
Page 172: ...Index Index 4 T Series Traffic Director Installation Configuration and Administration Guide...