Citrix ByteMobile T1010, Installation, Configuration And Administration

Page: 48 / 172

2-8 T-Series Traffic Director Installation, Configuration and Administration Guide
Chapter 2 Installing the T1000
Rack Mounting the T1000
The T1000 can be installed in standard server racks that conform to EIA-310-D
specification. The T1000 ships with a set of rails, which you must install before you mount
the T1000. The only tools that you need for installing a T1000 are a Phillips screwdriver and
a flathead screwdriver.
Each T1000 ships with a mounting rail kit that contains two rail assemblies, one for the left
side and the other for the right side of the T1000, and screws to attach the rails. An assembly
consists of an inner rail and a rack rail.
Note: The same rail kit is used for both square-hole and round-hole racks. There are
specific instructions for threaded, round-hole racks, described below.
Perform the following tasks to mount the T1000:
• Remove the inner rails from the rail assembly.
• Attach the inner rails to the T1000.
• Install the rack rails on the rack.
• Install the T1000 in the rack.
Before beginning the rack mounting procedure, review “Cautions and Warnings” on
page 2-2.
Removing the Inner Rails from the Rail Assembly
Step 1 Place the rail assembly on a flat surface.
Step 2 Slide out the inner rail toward the front of the assembly.
Step 3 Depress the latch until the inner rail comes all the way out of the rail assembly.
Step 4 Repeat steps 1 through 3 to remove the second inner rail.
Attaching the Inner Rails to the T1000
Step 1 Position the right inner rail behind the handle on the right side of the T1000.
Step 2 Align the holes on the rail with the corresponding holes on the side of the T1000.
Step 3 Attach the rail to the T1000 with the provided screws: 5 per side as shown in the following
figure.
Note: The following figure shows the T1100 hardware model. Procedure and rail
location are similar for T1010 and T1200 models.