1/2
B740 Abbreviated instruction
• This watch is solar-powered. Expose the dial to light and use it sufficiently charged.
• To see details of charging time, specifications and operations, refer to the instruction manual: B740 instruction manual
English
Component identification
Function hand/Power
reserve indication
Water sensor
Hour hand
Mode hand (DV)
24-hour hand
Second hand
Pressure sensor
Button
B
Button
A
Minute hand
Crown
Date indication
Crown's position
0 1 2
• Actual appearance may differ from the illustration.
• The crown has two positions when pulling it out.
• Refer also to our web page for detail of usage of the
scale and bezel on the watch.
(
http://www.citizenwatch-global.com/support/pdf/enhanced/e.pdf
)
• Rotate the screw down crown counterclockwise until it releases from the case
before operating it. After operation, with pressing it to the case, rotate the crown
clockwise to tighten it firmly.
Changing the mode
You can switch two modes on the watch; the time mode and the chronograph
mode.
1.
Press and hold lower right button
A
for 2 seconds or more.
• Each time you press and hold button
A
, the two modes switch alternately.
Mode
Chronograph
Time
Indication
Position of the
function hand
0
Current power reserve level
Position of the
mode hand
0
DV
To check the power reserve level
While the watch is in time mode, the function hand points to the current power
reserve level.
• When the watch changes into the dive mode, the current power reserve level is
not shown.
To change into the dive mode
The watch changes into the dive mode automatically as the water sensor gets wet
while it is in time mode.
• It does not change into the dive mode when the function hand points “NG”.
Setting the time
1.
Press and hold the lower right button
A
to change the mode to
the time mode.
The mode hand points to “DV”.
2.
Pull the crown out to position
2
when the
second hand points 0 second.
The function hand points the 0 second position.
3.
Rotate the crown to set the time.
4.
Push the crown in to position
0
in accordance with a reliable
time source to finish the procedure.
The second hand starts moving.
Setting the date indication
• Do not adjust the date indication while the watch shows 9:00 PM ‒ 1:00 AM.
Otherwise, the date indication may change incorrectly thereafter.
1.
Pull the crown out to position
1
.
2.
Rotate the crown to adjust the date indication.
3.
Push the crown in to position
0
to finish the procedure.
