- 470 -
4.2.3 MSW3
●
MSW3-1
:
Auto-cutter return
[Outline]
Selects the return method from cutter lock error.
OFF(0)
ON(1)
Resum Cttr Err
Valid
Invalid
ON (1) OPERATION: Return by command.
After removing error cause, return with command <DLE ENQ n>.
OFF (0) OPERATION: Return with FEED switch.
After removing error cause, return by long pressing FEED SW (1 sec or longer).
●
MSW3-2
:
Clearing Cover Open Error
[Outline]
Selects the method of clearing Cover Open error.
(CT-S300 unique)
OFF(0)
ON(1)
Resum Open Err
Close
Command
Operation at ON (1):
When the printer detects that cover is closed and the printer receives a command <DLE+ENQ+n>, the
error is cleared.
Operation at OFF (0):
When the printer detects that the cover is closed, it automatically clears the error.
●
MSW3-2
：
Paper end signal output at detecting paper near end
(Only for CT-S801(II)/CT-S851(II)/CT-S601(II)/CT-S651(II)/CT-S251/CT-D151/CT-E651)
[Outline]
Selects the Valid/Invalid of PE signal at detecting PNE
OFF(0)
ON(1)
PE output at PNE
Valid
Invalid
OPERATION at ON (1):
When paper near end is detected, printer output the PE signal from parallel interface or USB interface. This
is same behavior of ESC
ｃ
3 n command and n=15.
OPERATION at OFF (0):
When paper near end is detected, printer does not output the PE signal from parallel interface or USB
interface. This is same behavior of ESC c 3 n and n=12.
