R E V I E W D R A F T # 1 — C I S C O C O N F I D E N T I A L
A-19
Cisco WRP500 Administration Guide
Appendix A Advanced Voice Fields
Regional page
Voice tab > Regional page >
Control Timer Values (sec) section
Hook Flash Timer
Min
Minimum on-hook time before off-hook qualifies as hook-flash.
Less than this the on-hook event is ignored. Range: 0.1–0.4
seconds.
The default is
0.1
.
Hook Flash Timer
Max
Maximum on-hook time before off-hook qualifies as hook-flash.
More than this the on-hook event is treated as on-hook (no
hook-flash event). Range: 0.4–1.6 seconds.
The default is
0.9
.
Callee On Hook Delay Phone must be on-hook for at this time in sec before the WRP500
will tear down the current inbound call. It does not apply to
outbound calls. Range: 0–255 seconds.
The default is
0
.
Reorder Delay
Delay after far end hangs up before reorder tone is played. 0 = plays
immediately, inf = never plays. Range: 0–255 seconds.
The default is
5
.
Call Back Expires
Expiration time in seconds of a call back activation. Range:
0–65535 seconds.
The default is
1800
.
Call Back Retry Intvl Call back retry interval in seconds. Range: 0–255 seconds.
The default is
30
.
Call Back Delay
Delay after receiving the first SIP 18x response before declaring the
remote end is ringing. If a busy response is received during this
time, the WRP500 still considers the call as failed and keeps on
retrying.
The default is
0.5
.
VMWI Refresh Intvl
Interval between VMWI refresh to the CPE.
The default is
0.5
.
Interdigit Long Timer Long timeout between entering digits when dialing. The interdigit
timer values are used as defaults when dialing. The
Interdigit_Long_Timer is used after any one digit, if all valid
matching sequences in the dial plan are incomplete as dialed.
Range: 0–64 seconds.
The default is
10
.
