D15362.16 DX70 and DX80 Administrator Guide CE9.13, JUNE 2020.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
119
Cisco Webex DX70 and DX80
Administrator Guide
Conference DefaultCall Protocol
Define the Default Call Protocol to be used when placing calls from the device.
Requires user role: ADMIN
Default value: Auto
Value space: Auto/H320/H323/Sip/Spark
Auto: Enables auto-selection of the call protocol based on which protocols are available.
If multiple protocols are available, the order of priority is: 1) SIP; 2) H323; 3) H320. If the
device cannot register, the auto-selection chooses H323.
H320: All calls are set up as H.320 calls (only applicable if used with Cisco TelePresence
ISDN Link).
H323: All calls are set up as H.323 calls.
Sip: All calls are set up as SIP calls.
Spark: Reserved for Webex registered devices. Do not use.
Conference DefaultCall Rate
Define the Default Call Rate to be used when placing calls from the device.
Requires user role: ADMIN, INTEGRATOR
Default value: 3072
Value space: Integer (64..3072)
The default call rate (kbps).
Conference DoNotDisturb DefaultTimeout
This setting determines the default duration of a Do Not Disturb session, i.e. the period
when incoming calls are rejected and registered as missed calls. The session can be
terminated earlier by using the user interface.
Requires user role: ADMIN, INTEGRATOR
Default value: 60
Value space: Integer (1..1440)
The number of minutes (maximum 1440 minutes = 24 hours) before the Do Not Disturb
session times out automatically.
Conference Encryption Mode
Define the conference encryption mode. A padlock with the text "Encryption On" or
"Encryption Off" displays on screen for a few seconds when the conference starts.
NOTE: If the Encryption Option Key is not installed on the device, the encryption mode is
always Off.
Requires user role: ADMIN
Default value: BestEffort
Value space: Off/On/BestEffort
Off: The device will not use encryption.
On: The device will only allow calls that are encrypted.
BestEffort: The device will use encryption whenever possible.
> In Point to point calls: If the far end device supports encryption (AES-128), the call will
be encrypted. If not, the call will proceed without encryption.
> In MultiSite calls: In order to have encrypted MultiSite conferences, all sites must
support encryption. If not, the conference will be unencrypted.
Conference FarEndControl Mode
Lets you decide if the remote side (far end) should be allowed to select your video sources
and control your local camera (pan, tilt, zoom).
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: The far end is not allowed to select your video sources or to control your local
camera (pan, tilt, zoom).
On: Allows the far end to be able to select your video sources and control your local
camera (pan, tilt, zoom). You will still be able to control your camera and select your
video sources as normal.
Introduction
Configuration
Peripherals
Maintenance
Device settings
Appendices
Device settings
