Step 4
Insert the two plastic battery tabs directly into the two battery compartment slots.
Step 5
Use the tab and slot contact point as a pivot to lower the battery into the compartment.
Step 6
Use your finger to press down until you feel and hear the battery clip snap into place.
Related Topics
, on page 36
Remove the Battery
Battery removal follows a reversed but similar procedure to battery insertion.
The steps to remove the battery are the same for both the Cisco Webex Wireless Phone 860 and Cisco Webex
Wireless Phone 840. However, the battery contacts are in different locations on these models. The illustrations
in the following steps are of the Cisco Webex Wireless Phone 860.
Cisco Webex Wireless Phone 800 Series User Guide
33
Phone Setup
Remove the Battery
Summary of Contents for Webex 800 Series
Page 10: ...Cisco Webex Wireless Phone 800 Series User Guide x Contents ...
Page 40: ...Cisco Webex Wireless Phone 800 Series User Guide 30 Your Phone Battery Warranty ...
Page 76: ...Cisco Webex Wireless Phone 800 Series User Guide 66 Emergency App Cancel the Panic Alarm ...
Page 94: ...Cisco Webex Wireless Phone 800 Series User Guide 84 Barcode App Clean the Scanner Window ...
