Cisco WAP300N, User Manual

Page: 138 / 660

15
Setting Up: Basics
Linksys WAP300N
Depending on the security mode you select, you may be asked to enter
additional information Refer to the following table
Security mode
Information
Required Description
WPA/WPA2
Personal
Passphrase
Enter the passphrase shared by this
device and your wireless router (or
access point)
WEP
Encryption
Select a level of WEP encryption, 40 /
64-bit (10 hex digits) or 104 / 128-bit
(26 hex digits)
Key 1
Enter the WEP key of your network
Key 1 is the transmit key used by this
device
Authentication
The default is Auto , which allows
either open system or shared
key authentication to be used
Select Open to use open system
authentication (a WEP key is not used
for authentication) Select
Shared to
use shared key authentication (a WEP
key is used for authentication)
5.
Click
Save Settings
How to use Wireless Range Extender
mode
How to select Wireless Range Extender mode
To select Wireless Range Extender mode:
Setup > Operation Mode
1.
Log into the browser-based utility (see “How to open the browser-based
utility” on page 8)
2. Click the Setup tab, then click the Operation Mode page
3.
Select
Wireless Range Extender
, then click
Save Settings