Configuring the ISDN gateway
11
Configuring the ISDN gateway
Step one: Log in to the ISDN gateway
All administration of the ISDN gateway is performed via the web interface.
To log in to the ISDN gateway:
1
Log in to the Supervisor’s web interface.
2
Go to
Hardware > Blades
and click the IP address of the ISDN gateway.
3
Click
Log in
and enter the user name
admin
with no password. The
Login
information page
is displayed.
Step two: Allocate port licences
Port licenses must be allocated to the ISDN gateway from the Supervisor's
Port
licenses
page. Refer to the online help for assistance.
Step three: Set up the ISDN interfaces
1
In the web interface, go to
Settings > ISDN
.
2
Select the
ISDN interface type
to match that of your installation; E1 is typically
used in the UK and mainland Europe, T1 (USA and Canada) in North America,
and T1(Japan) in Japan.
3
Complete the other settings as required by your network, referring to the online
help for further information.
4
Click
Apply changes
to save any changes you have made to the configuration.
5
Restart the ISDN gateway (this is only necessary if you changed the ISDN
configuration). To do this:
i
Go to
Settings > Shutdown
, and click
Shut down ISDN GW
.
ii
Confirm that you want to shut down the ISDN gateway.
iii Click
Restart ISDN GW
.
6
When the ISDN gateway has restarted, log in to the web interface again, and go
to
Settings > ISDN ports
.
Cisco recommends that you change the admin account to use a password
as soon as possible. To do that, click
Change password
on the
Login
information
page or go to
Users
, click the
admin
link, and provide the
required user information.
i
