Cisco Sx350, Cli Manual

Page: 768 / 1323

Link Layer Discovery Protocol (LLDP) Commands
767 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
36
Example
The following example enables LLDP MED with the location TLV on gi13.
switchxxxxxx(config)# interface gi13
switchxxxxxx(config-if)# lldp med enable location
36.7 lldp med notifications topology-change
To enable sending LLDP MED topology change notifications on a port, use the lldp
med notifications topology-change Interface (Ethernet) Configuration mode
command. To restore the default configuration, use the no form of this command.
Syntax
lldp med notifications topology-change
{enable | disable}
no lldp med notifications topology-change
Parameters
•
enable—Enables sending LLDP MED topology change notifications.
•
disable—Disables sending LLDP MED topology change notifications.
Default Configuration
Disable is the default.
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example enables sending LLDP MED topology change notifications
on
gi1
2.
switchxxxxxx(config)# interface gi12
switchxxxxxx(config-if)# lldp med notifications topology-change enable