Cisco Sx350, Cli Manual

Page: 296 / 1323

DHCP Server Commands
295 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
12
12.7 default-router
To configure the default router list for a DHCP client, use the default-router
command in DHCP Pool Network Configuration mode or in DHCP Pool Host
Configuration mode. To remove the default router list, use the no form of this
command.
Syntax
default-router ip-address [ ip-address2 ... ip-address8 ]
no default-router
Parameters
•
ip-address
[
ip-address2
...
ip-address8
]—Specifies the IP addresses of
default routers. Up to eight addresses can be specified in one command
line.
Command Mode
DHCP Pool Network Configuration mode
DHCP Pool Host Configuration mode
Default Configuration
No default router is defined.
User Guidelines
The router IP address should be on the same subnet as the client subnet.
If the auto-default-router command is configured then the DHCP server returns
an
IP address defined on the input interface as a default router when an default router is not configured in
the following case:

Default router is not configurable.
 DHCP client is directly connected.

IP Routing is enabled.
 Default router was required by the client.
Example
The following example specifies 10.12.1.99 as the default router IP address.
switchxxxxxx(config-dhcp)#
default-router
10.12.1.99