Cisco Sx350, Cli Manual

Page: 142 / 1323

Address Table Commands
141 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
4
switchxxxxxx(config-if)#
bridge multicast source 2001:0:0:0:4:4:4 group
FF00:0:0:0:4:4:4:1
4.13 bridge multicast ipv6 forbidden source
group
To forbid adding or removing a specific IPv6 source address - Multicast address
pair to or from specific ports, use the bridge multicast ipv6 forbidden source
group Interface (VLAN) Configuration mode command. To return to the default
configuration, use the no form of this command.
Syntax
bridge multicast ipv6 forbidden
source ipv6-source-address
group
ipv6-multicast-address {add | remove} {ethernet interface-list | port-channel
port-channel-list
}
no bridge multicast ipv6 forbidden source
ipv6-address
group
ipv6-multicast-address
Parameters
•
ipv6-source-address—Specifies the source IPv6 address.
•
ipv6-multicast-address—Specifies the group IPv6 Multicast address.
•
add—Forbids adding ports to the group for the specific source IPv6
address.
•
remove—Forbids removing ports from the group for the specific source
IPv6 address.
•
ethernet
interface-list
—Specifies a list of Ethernet ports. Separate
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
•
port-channel port-channel-list —Specifies a list of port channels. Separate
nonconsecutive port-channels with a comma and no spaces; use a hyphen
to designate a range of port channels.
Default Configuration
No forbidden addresses are defined.