Cisco Sx350, Cli Manual

Page: 1003 / 1323

Rate Limit and Storm Control Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 1002
50
Use the clear storm-control counters interface
interface-id
command to clear all
the storm control counters of a given port.
Use the clear storm-control counters broadcast | multicast | unicast command to
clear all storm control counters of a given traffic type of all Ethernet ports.
Use the clear storm-control counters broadcast | multicast | unicast interface
interface-id command to clear one storm control counter of a given traffic type and
of a given port.
Example
Example 1. The following example clears all storm control counters of all ports:
switchxxxxxx#
clear storm-control counters
Example 2. The following example clears all storm control counters of port gi11:
switchxxxxxx# clear storm-control counters interface gi11
Example 3. The following example clears broadcast storm control counter of all
ports:
switchxxxxxx# clear storm-control counters broascat
Example 4. The following example clears multicast storm control counter of port
gi11:
switchxxxxxx# clear storm-control counters multicast interface gi11
50.2 rate-limit (Ethernet)
To limit the incoming traffic rate on a port, use the rate-limit command in Interface
(Ethernet) Configuration mode. To disable the rate limit, use the no form of this
command.