Table 12. Summary of Firmware Provisioning Tasks on the SV-4K and DMP 4310G
Firmware Provisioning Tasks
SV-4K
DMP
4310G
Upload firmware to Cisco StadiumVision Director in the
Management Dashboard
Yes
Yes
Configure "Firmware image to use" and "init.version" under Auto
Registration Settings.
Yes
Yes
1
Upgrade the firmware from the Management Dashboard by
selecting DMPs and running the Firmware Upgrade command to
push the firmware to the device.
No
Yes
1
The DMP 4310G also uses the "init.build" property which does not apply to the SV-4K media
player.
Auto-Provisioning on the SV-4K
l
The SV-4K is automatically provisioned with global configuration settings from
Cisco StadiumVision Director—but not in the same way as occurs for the Cisco
DMP 4310G.
As part of the start-up sequence, the SV-4K retrieves the Cisco StadiumVision
Director configuration, which includes all of the global settings for the SV-4K, such
as NTP configuration, jitter settings, and so on.
l
The SV-4K global settings are configured in the Management Dashboard by
going to:
SV Director Configuration
>
Global DMP Settings
>
SV-4K Settings
.
l
The SV-4K configuration in Cisco StadiumVision Director is provisioned each
time that the SV-4K device boots.
IMPORTANT:
If you are running Cisco StadiumVision Director
on a virtual server, then you should reference a reliable
NTP server running on a bare metal server, rather than relying on
a clock from a VM environment that can drift and is not accurate.
NTP for Cisco StadiumVision Director is configured using the
TUI, and can be the same external server as is used for the Cisco
DMP 4310G devices. For more information, see the
StadiumVision Director Server Administration Guide.
IR Receiver for the SV-4K
There is not an embedded IR receiver on the SV-4K. You must use the IR extender
cable to use the IR Remote.
16 of 68
© Cisco Systems, Inc. All rights reserved.
