Set Up the SPA3000
Document ID: 108740
Contents
Introduction
How do you initially set up an SPA3000?
Related Information
Introduction
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business
products (formerly Linksys Business Series).
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Q. How do you initially set up an SPA3000?
A. In setting up the SPA3000, make sure you have a one touch tone analog phone, your
NodePhone account details, and access to a standard phone port. You should also have these
package contents:
Phone Adapter Unit
♦
Ethernet Cable Standard Phone Cable
♦
A 5 Volt Power Adapter
♦
Note: This guide has been prepared with firmware 2.0.13, the current supported firmware
release for NodePhone. If you are using an earlier firmware, the web configuration screen
might not look the same as the images in this document. Cisco recommends upgrading your
SPA3000 to version 2.0.13, which is available from the Cisco Download Center (
registered
customers only
) .
In order to set up the SPA3000, complete these steps:
Ensure the SPA3000 Power Supply is Connected Properly
1.
Connect the SPA3000
2.
Ensuring the SPA3000 Power Supply is Connected Properly
Make sure the power adapter is plugged to an available power outlet.
1.
