Status and Statistics
Diagnostics
57
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
4
•
Distance to Fault
—Distance from the port to the location on the cable where the fault
was discovered.
•
Operational Port Status
—Displays whether port is up or down.
The
Advanced Information
block contains the following information, which is refreshed
each time you enter the page:
•
Cable Length:
Provides an estimate for the length.
•
Pair
—Cable wire pair being tested.
•
Status
—Wire pair status. Red indicates fault and Green indicates status OK.
•
Channel
—Cable channel indicating whether the wires are straight or cross-over.
•
Polarity
—Indicates if automatic polarity detection and correction has been activated
for the wire pair.
•
Pair Skew
—Difference in delay between wire pairs.
Optical Module Status
The Optical Module Status page displays the operating conditions reported by the SFP (Small
Form-factor Pluggable) transceiver.
The following GE SFP (1000Mbps) transceivers are supported:
•
MGBBX1: 1000BASE-BX-20U SFP transceiver, for single-mode fiber, 1310 nm
wavelength, supports up to 40 km.
•
MGBLH1: 1000BASE-LH SFP transceiver, for single-mode fiber, 1310 nm
wavelength, supports up to 40 km.
•
MGBLX1: 1000BASE-LX SFP transceiver, for single-mode fiber, 1310 nm
wavelength, supports up to 10 km.
•
MGBSX1:1000BASE-SX SFP transceiver, for multimode fiber, 850 nm wavelength,
supports up to 550 m.
•
MGBT1: 1000BASE-T SFP transceiver for category 5 copper wire, supports up to
100 m.
The following XG SFP+ (10,000Mbps) transceivers are supported:
•
Cisco SFP-10GSR
