Cisco SE680 WiMAX, User Manual

Page: 36 / 67

36
Device status
SE680 WiMAX / engbt / SE680_FUG_EN-7 / Status.fm / 13.5.11
Schablo
ne 2005_05_
02
Local network LAN
Status > Local Network
The configuration of the local network is displayed in the Local Network submenu.

If necessary, click the Refresh button to refresh the data in the status display.
Device status
Status > Device Status
The device status of your SE680 WiMAX is displayed in the Device Status submenu.

If necessary, click the Refresh button to refresh the data in the status display.
IP address IP address used by the SE680 WiMAX in your local network.
Default: 192.168.2.1
Subnet mask Subnet mask of your local network. Default: 255.255.255.0
MAC address The MAC address uniquely identifies a network component
within a network, in this case the local MAC address of your
SE680 WiMAX within your local network.
DHCP server Displays whether the DHCP server of your SE680 WiMAX is
activated. As DHCP server, your SE680 WiMAX assigns an IP
address to all the PCs in the network. If the DHCP server is
activated, you will see the network subscribers that have
received your IP address from the DHCP server in the
DHCP
clients field. DHCP must be activated on a PC for the PC to
receive an IP address from the DHCP server. For more infor-
mation see the document "Configuring the local area network"
on the product CD.
System uptime Operating time of your SE680 WiMAX since it was last
restarted. The operating time is given in the format
ddd:hh:mm:ss (d=days, h=hours, m=minutes, s=seconds).
System time Displays the current date and time. This information is trans-
mitted to your SE680 WiMAX by the WiMAX network.
Operating Mode Role played by your SE680 WiMAX during connection setup to
the Internet (
Router or Bridge ).
Device temperature Current device temperature inside your SE680 WiMAX. In the
event of overheating, the SE680 WiMAX switches off.
System Log Error protocol in which you will find information about prob-
lems.