32
Restoring factory settings
SE680 WiMAX / engbt / SE680_FUG_EN-7 / Administration.fm / 13.5.11
Schablo
ne 2005_05_
02
Changing the password
Enter the current password in the
Current password
field. If no default system
password has been set, leave this field empty.
Enter a new password in the
New password
field.
– Select any series of characters with a minimum length of 4 and a maximum
length of 20 characters. You can use the following characters: A–Z, a–z, 0–9 as
well as the following special characters: ! “ # $ % & ’ ( ) * + , - . / : ; < = > ? @ [ \
] ^ _ { | } ~.
– Note down your new password on a sheet of paper and store it in secure place.
Enter your new password in the
Confirm new password
field again. This entry is
case-sensitive.
The new password can only be activated if both entries match. This detects typing
errors when the password is entered.
Finally, click
Ok
to accept your change and to activate the new password.
The new password is valid immediately for each instance the configuration is called
up.
Restoring factory settings
You can reset the SE680 WiMAX to the factory settings. You should do this before mak-
ing the device available to others or exchanging it through the dealer. Otherwise unau-
thorised users may use the Internet access data at your expense.
Open the
Advanced Settings
tab and on the
Administration
menu select
Factory
reset
.
Click
Ok.
A window will appear prompting you to confirm the procedure.
!
The configuration of the SE680 WiMAX cannot be accessed if you
do not enter a valid password.
In this case, you must restore all the fac-
tory settings of the SE680 WiMAX modem.
i
Please remember that when the device is fully reset,
all
the configuration
settings are returned to the factory settings. This means that you will
have to completely reconfigure the SE680 WiMAX.
Summary of Contents for SE680 WiMAX
Page 2: ......
