B-1
Cisco SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-07
A P P E N D I X
B
CLI Commands to Verify a Successful Installation
Revised: July 27, 2009, OL-7824-07
Introduction
When you have completed the installation of your Cisco SCE 2000 platform, we recommend that you
run a number of CLI commands to verify that the proper components have been successfully installed
and are operational.
Basic Post-Installation Checklist
The following table provides a basic post-installation checklist with the related CLI commands. Further
verification of the system configuration would depend on the specific topology and configuration of the
installation, but this list will verify that the basic installation is operational.
Refer to the descriptions of the individual commands for samples of the command output. Relevant
information in the output is in
bold
.
To check this:
Use this command:
Comments
version
Check the following:
•
firmware version
•
application version
•
management agent status
•
management agent version
•
optic mode
port configuration
Run this command for each port to get a listing of the status
and configuration of all ports.
operational status
show system operational status
Status should be
operational
.
This command will give you an indication of problems such
as a power problem or external bypass not configured
properly.
linecard status
It should not be
shutdown
or
silent
.
