Administration
LLDP Properties Configuration
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide
134
8
LLDP Properties Configuration
LLDP is a neighbor discovery protocol that is used for network devices to
advertise their information to other devices on the network. This protocol runs
over the data-link layer, which allows two systems running different network layer
protocols to learn about each other.
To enable LLPD properties on the router, follow these steps:
STEP 1
Select
Administration >LLDP Properties.
STEP 2
Check
Enable
to enable the following: LLPD status, DSL_ATM_WAN_0_33_R,
ETH_WAN_R, DSL_PTM_WAN_1_1_R, IP_USB, PPP_USB.
STEP 3
Click
Save.
Time Settings Configuration
You can configure your time zone, whether or not to adjust for Daylight Savings
Time, and with which Network Time Protocol (NTP) server to synchronize the date
and time. The router then gets its date and time information from the NTP server.
To configure NTP and time settings:
STEP 1
Select
Administration
>
Time Settings
. The current time is displayed.
STEP 2
Enter information in the following fields:
Time Zone
Select your time zone, relative to Greenwich Mean
Time (GMT).
Adjust for Daylight
Savings Time
If supported for your region, check the
Adjust for
Daylight Savings Time
box.
Daylight Saving Mode
If you select
By date
, enter the specific date when
daylight saving mode starts.
If you select
Recurring
,
enter the month, week, the
day of the week, and time when daylight saving
time starts.
Enter the appropriate information in the
From
and
To
fields.
