Cisco Remote PHY Shelf 7200, Software Configuration Manual And Command Reference

Page: 94 / 116

Verify IPv6 PTP Clock Option Configuration
To display the CBR PTP Status, use the
show ptp clock running
command as shown in the example below:
Router#
show ptp clock running
Load for five secs: 6%/2%; one minute: 7%; five minutes: 8%
No time source, *05:11:13.610 UTC Sun Oct 22 2017
PTP Ordinary Clock [Domain 0]
State Ports Pkts sent Pkts rcvd Redundancy Mode
PHASE_ALIGNED 1 2478203 7512533 Hot standby
PORT SUMMARY
PTP Master
Name Tx Mode Role Transport State Sessions Port Addr
slave-from-903 unicast slave Lo15888 Slave 1 10.90.3.93
To display the RPD PTP Status, use the
show ptp clock
command as shown in the example below:
Router#
show ptp clock 0 config
Domain/Mode : 0/OC_SLAVE
Priority 1/2/local : 128/255/128
Profile : 001b19000100-000000 E2E
Total Ports/Streams : 1 /1
--PTP Port 23, Enet Port 1 ----
Port local Address :2001:120:102:70:7:1b71:476c:70ba
Unicast
Duration :300 Sync Interval : -4
Announce Interval : 0 Timeout : 11
Delay-Req Intreval : -4 Pdelay-req : -4
Priority local :128 COS: 6 DSCP: 47
==Stream 0 : Port 23 Master IP: 2001:10:90:3::93
Router#
show ptp clock 0 state
apr state : PHASE_LOCK
clock state : SUB_SYNC
current tod : 1508640223 Sun Oct 22 02:43:43 2017
active stream : 0
==stream 0 :
port id : 0
master ip : 2001:10:90:3::93
stream state : PHASE_LOCK
Master offset : 3490
Path delay : -27209
Forward delay : -27333
Reverse delay : -27085
Freq offset : 6544364
1Hz offset : 49
Router#
show ptp clock 0 statistics
AprState 4 :
2@0-00:06:25.027 1@0-00:06:15.382 0@0-00:03:51.377
4@0-00:03:32.176
ClockState 5 :
5@0-00:06:36.141 4@0-00:06:33.684 3@0-00:06:30.510
2@0-00:06:25.512 1@0-00:06:24.982
BstPktStrm 1 :
0@0-00:06:15.987
StepTime 1 :
908222863@0-00:05:42.199
AdjustTime 2589 :
-339@1-20:18:42.949 -321@1-20:17:41.949 49@1-20:16:40.949
145@1-20:15:39.949 6@1-20:14:38.949 261@1-20:13:37.949
327@1-20:12:36.949 76@1-20:11:35.949 157@1-20:10:34.949
streamId msgType rx rxProcessed lost tx
Cisco Remote PHY Shelf 7200 Software Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
82
Cisco Remote PHY Shelf 7200 Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
Verify IPv6 PTP Clock Option Configuration