Cisco Remote PHY Shelf 7200, Software Configuration Manual And Command Reference

Page: 45 / 116

Table 10: show cable rpd dlm Field Descriptions
Description Field
It means the last time average DLM (AD). At first, the Last Average DLM (LAD) is
always 0, when the absolute value of (LAD - AD) exceeds or equal to 75us, LAD will
be updated to be the value of AD, MAP advance triggered to update, AD will keep
updating with the last (latest) 10 samples. Last Average DLM
Example: DLM Configuration
The following example shows how to configure DLM:
Router# configure terminal
Router(config)#cable rpd 1
Router(config-rpd)#core-interface tenGigabitEthernet 3/1/0
Router(config-rpd-core)#network-delay dlm 10
Feature Information for DLM
Use Cisco Feature Navigator to find information about the platform support and software image support.
Cisco Feature Navigator enables you to determine which software images support a specific software release,
feature set, or platform. To access Cisco Feature Navigator, go to the
www.cisco.com/go/cfn link. An account
on the Cisco.com page is not required.
The following table lists the software release in which a given feature is introduced. Unless noted otherwise,
subsequent releases of that software release train also support that feature. Note
Table 11: Feature Information for DLM
Feature Information Releases Feature Name
This feature was introduced on the Cisco
Remote PHY Shelf 7200. Cisco Remote PHY Shelf 7200
Software 1.1 DEPI Latency Measurement
Cisco Remote PHY Shelf 7200 Software Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
33
Cisco Remote PHY Shelf 7200 Start Up Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
Example: DLM Configuration