4-41
Cisco Carrier Sensitive Routing User Guide
Chapter4 CSR GUI Functionalities
CSR Commands
Figure4-38 Destroy Message in Inactive Dataset
Step 2
Click Yes to destroy the inactive dataset, or No to quit destroying.
Activating Inactive Datasets
An inactive dataset is not loaded into the CSR memory, with the exception of test commands. To place
the dataset in the CSR memory for routing, use the following steps:
Step 1
In the Inactive Dataset tab in the CSR window, click Verify Dataset in the Dataset Commands area to
verify the inactive dataset.
Step 2
Click the Configuration Management tab, and click Swap Active/Inactive Datasets to swap the inactive
dataset to active dataset.
Step 3
In the Select Dataset box, click Load Dataset into CSR.
Step 4
Click Swap to swap the datasets, or click
Cancel
to cancel swapping.
Also see
“Swapping Datasets ” section on page4-12
.
CSR Commands
This section describes how to use the CSR Commands tab in the CSR window for the following
functionalities:
•
Sending Test Route Request Commands to an Active CSR Application, page 4-42
•
Updating Logging Level , page 4-44
•
Loading the Active Dataset, page 4-44
•
Resetting Call Accounting, page 4-45
•
Updating Gatekeepers , page 4-45
•
Cleaning Test Results , page 4-45