May 2002
Document Number: 78-11505-01
Connecting an AC Power Cord
To connect an AC power cord to a CSS 11800:
1.
Ensure that the CSS power switch is in the
0
(off) position.
2.
Attach the power cord to the CSS by plugging the AC power cord connector into the power receptacle at the front of
the chassis as shown in the illustration below.
3.
Plug the power cord into a dedicated 3-wire grounding receptacle.
4.
Switch on the power on the CSS.
Removing a Power Supply
To remove a power supply:
1.
If necessary, power down the CSS (if no redundant power supply is installed).
2.
Loosen the captive panel fasteners on the power supply front panel.
3.
Grasp the power supply handle and carefully pull the power supply out of the chassis.
PS1 AC Power Cord
PS1
PS2
PS1 Power Switch
PS2 AC Power Cord
PS2 Power Switch