Cisco PrecisionHD 1080p12x, User Manual, Page: 25 / 37

Cisco TelePresence PrecisionHD Camera
D14640.12 Cisco Telepresence PrecisionHD Camera User Guide TC6.2, August 2013.
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
25
User Guide
PrecisionHD 1080p12x
The information on this page applies to the PrecisionHD 1080p12x
camera. The camera has DIP switches for video output format
setting.
NOTE: The early shipments of the Quick Set C20 came with
an interim version of the PrecisionHD 1080p4x camera (the
PrecisionHD 1080p 4x* camera). The interim version has DIP
switches for video output format setting, see the table on this page.
Video output formats
The DIP switches 1 to 5 set the video output format for the
camera. The DIP switches are located under the camera. The
default setting is Auto , see the table to the right.
Maximum resolution:
• 1080p60 for PrecisionHD 1080p12x zoom
• 1080p30 for PrecisionHD 1080p4x* zoom
• 1080p30 for HD-SDI**
Line voltage frequency
The camera automatically detects the line voltage frequency
when it is 50 or 60 Hz. If there is a different line voltage, you
can set the video output format to a specific value (use the DIP
switches) to override the auto frequency detection.
Set the PrecisionHD 1080p DIP switch (country specific setting):
• 50Hz: 00011, gives 1080p50 (720p50 for HD-SDI)
• 60Hz: 00100, gives 1080p60 (720p60 for HD-SDI)
DIP Switch table for video output formats
1 2 3 4 5 HDMI HD-SDI**
0 0 0 0 0 Auto
0 0 0 0 1 1920x1080p25 1920x1080p25
0 0 0 1 0 1920x1080p30 1920x1080p30
0 0 0 1 1 1920x1080p50** 1280x720p50***
0 0 1 0 0 1920x1080p60** 1280x720p60***
0 0 1 0 1 1280x720p25 1280x720p25
0 0 1 1 0 1280x720p30 1280x720p30
0 0 1 1 1 1280x720p50** 1280x720p50***
0 1 0 0 0 1280x720p60** 1280x720p60***
0 1 0 0 1 Software control
The table shows the different settings available
for the HDMI and the HD-SDI outputs.
Auto : Camera negotiates format over HDMI.
HD-SDI tracks HDMI and defaults to 1080p30 in
absence of HDMI sync. This is the default setting.
Software : For more on the Software control set-
ting, read about video mode selections in the
Appendix section. Go to:

Controlling cameras
using the VISCA™ protocol .
* Available for a limited period of time.
** Not supported with Codec C20.
*** Do not use with the PrecisionHD 1080p4x* camera.
DIP switch table
PrecisionHD 1080p12x, from below
The DIP switches 1 to 5
0
1
Contents Introduction The Physical Interface Connecting the Camera Appendices Daisy Chaining Video Output Format Video Output Format