5-6
Cisco PIX Security Appliance Hardware Installation Guide
78-15170-03
Chapter 5 PIX 520
PIX 520 Feature Licenses
If you are installing a DC voltage PIX security appliance, refer to the
“Installing the PIX 520 DC Model”
Step 6
The following options are available:
a.
If you have a second PIX security appliance to use as a failover unit, install the failover feature and
cable as described in the
“Installing Failover” section on page 5-7
Note
Do not power on the failover units until the primary unit is configured.
•
If needed, install the PIX security appliance syslog server as described in the
logging
command page
in the
online at:
http://www.cisco.com/en/US/products/sw/secursw/ps2120/prod_command_reference_list.html
b.
If you need to install an optional circuit board such as a single-port Ethernet board, or the four-port
Ethernet board, refer to the
“Installing a Circuit Board in the PIX 520” section on page 5-15
for
more information.
c.
If you need to install additional memory, refer to the
“Installing a Memory Upgrade” section on
If you are ready to start configuring the PIX security appliance, power on the unit. Refer to the
online at
:
http://www.cisco.com/en/US/products/sw/secursw/ps2120/prod_configuration_guides_list.html
Always check the
first before configuring the PIX security appliance for the latest release
details. You can find the latest versions of release notes online at:
http://www.cisco.com/en/US/products/sw/secursw/ps2120/prod_release_notes_list.html
PIX 520 Feature Licenses
If you have a PIX 520-UR unrestricted feature license, the following options are available:
•
If you have a second PIX 520 to use as a failover unit, install the failover feature and cable as
described in the
“Installing Failover” section on page 5-7
.
•
If needed, install the PIX security appliance syslog server as described in the
logging
command in
the
online at:
http://cisco.com/en/US/products/sw/secursw/ps2120/prod_command_reference_list.html
•
Refer to the
“Installing LAN-Based Failover” section on page 5-8
for information about how to
remove and replace the chassis cover if you need to install optional circuit boards.
Note
It is very important to remove the chassis cover before installing circuit boards in the PIX 520. Even
though it appears possible to add or remove circuit boards from the back panel, removing the chassis
cover greatly simplifies the process.
•
If you need to install additional memory, refer to the
