Cisco ONS 15454, Hardware Installation Manual

Page: 388 / 516

Figure 247: AC Power Modules Installed in the ONS 15454 M6 Shelf
Step 3
Return to your originating procedure (NTP).
DLP-G757 Replacing 15454-M6-AC With 15454-M6-AC2 Power module
This procedure is used to replace the 15454-M6-AC with 15454-M6-AC2 power
module. Purpose
#2 Phillips Dynamometric screwdriver Tools/Equipment
NTP-G259 Open and Remove the Standard Door of the ONS 15454 M6 Shelf ,
on page 327
.
Prerequisite Procedures
Required Required/As Needed
Onsite Onsite/Remote
None Security Level
Refer to Power Calculation, on page 478 to ascertain the power consumption of the shelf.
Note
Always use the supplied ESD wristband when working with a powered ONS 15454 M6. For detailed instructions
on how to wear the ESD wristband, see the
Electrostatic Discharge and Grounding Guide for Cisco CPT and
Cisco ONS Platforms .
Caution
Cisco ONS 15454 Hardware Installation Guide
358
Installing the ONS 15454 M6 Shelf
DLP-G757 Replacing 15454-M6-AC With 15454-M6-AC2 Power module