Cisco ONS 15454 Series, Procedure Manual

Page: 47 / 850

xlvii
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
About this Guide
Document Organization
Table 1 Cisco ONS 15454 Procedure Guide Chapters
Title Summary
Chapter 1, “Install the Shelf and Backplane
Cable” Includes procedures for installing the shelf
assembly, electrical interface assemblies (EIAs),
power and ground, fan-tray assembly, alarm
expansion panel, backplane wires, external
wire-wrap panel, electrical card cables, and
optional dense wavelength division multiplexing
(DWDM) equipment. Also included is the shelf
installation acceptance test.
Chapter 2, “Install Cards and Fiber-Optic Cable” Includes procedures to install common control
cards, optical cards, transponder and muxponder
cards, electrical cards, Ethernet cards and
connectors, FC_MR-4 cards, and DWDM cards.
Also included are procedures for removing and
replacing a card, preprovisioning a slot, and
installing and routing fiber-optic cables.
Chapter 3, “Connect the PC and Log into the
GUI” Includes procedures to install the Cisco Transport
Controller (CTC), set up a computer for different
connection types, and log into the
Cisco ONS 15454.
Chapter 4, “Turn Up Node” Includes procedures to verify the card installation;
create users and assign security; set up name, date,
time and contact information; set up network
access, firewall access, and timing; create
protection groups; and provision Simple Network
Management Protocol (SNMP).
Chapter 5, “Turn Up Network” Includes procedures to verify the node turn up, and
provision and test the following networks:
point-to-point, linear ADM, bidirectional line
switched ring (BLSR), and path protection. It also
includes procedures for subtending rings.
Chapter 6, “Create Circuits and VT Tunnels” Includes procedures to verify network turn up;
create manually or automatically routed circuits or
VT tunnels; create unidirectional circuits with
multiple drops; create VT aggregation points, half
circuits, Ethernet circuits, and overhead circuits;
provision a DWDM optical channel network
connection; and create virtual concatenated
(VCAT) circuits.
Chapter 7, “Manage Alarms” Includes procedures to document existing node
data, view and delete alarms, view alarm-affected
circuits and LCD alarm counts, manage alarm
profiles, filter alarms, suppress alarms, and
provision external alarms.