Cisco ONS 15454 Series, Procedure Manual, Page: 297 / 850

C H A P T E R
10-1
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
10
Change Node Settings
Note
The terms “Unidirectional Path Switched Ring” and “UPSR” may appear in Cisco literature. These terms
do not refer to using Cisco ONS 15xxx products in a unidirectional path switched ring configuration.
Rather, these terms, as well as “Path Protected Mesh Network” and “PPMN,” refer generally to Cisco’s
path protection feature, which may be used in any topological network configuration. Cisco does not
recommend using its path protection feature in any particular topological network configuration.
This chapter explains how to modify node provisioning for the Cisco ONS 15454. To provision a new
node, see
Chapter 4, “Turn Up Node.” To change default network element settings and to view a list of
those settings, refer to the “Network Element Defaults” appendix in the Cisco ONS 15454 Reference
Manual .
Before You Begin
Before performing the following procedures, investigate all alarms and clear any trouble conditions.
Refer to the
Cisco ONS 15454 Troubleshooting Guide as necessary.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
NTP-A81 Change Node Management Information, page 10-2 —Complete this procedure as needed
to change node name, contact information, latitude, longitude, date, time, and login legal disclaimer.
2. NTP-A201 Change CTC Network Access, page 10-2 —Complete this procedure as needed to change
the IP address, default router, subnet mask, network configuration settings, and static routes.
3.
NTP-A202 Customize the CTC Network View, page 10-3 —As needed, complete this procedure to
create domains and customize the appearance of the network map, including specifying a different
default map, creating domains, selecting your own map or image, and changing the background
color.
4. NTP-A203 Modify or Delete Card Protection Settings, page 10-4 —Complete as needed.
5.
NTP-A292 Modify or Delete Communications Channel Terminations and Provisionable Patchcords,
page 10-4
—Complete this procedure as needed to modify or delete DCC or LDCC terminations or
provisionable patchcords.
6. NTP-A85 Change Node Timing, page 10-5 —Complete as needed.
7.
NTP-A205 Modify Users and Change Security, page 10-6 —Complete this procedure as needed to
make changes to user settings, including security level and security policies, and to delete users.
8. NTP-A87 Change SNMP Settings, page 10-6 —Complete as needed.