The CTC session freezes until all circuits are repaired. Circuit repair can take up to five minutes or
more depending on the number of circuits provisioned.
Note
When the circuit repair is complete, the Circuits Repaired dialog box appears.
Step 26
Click
OK
.
Step 27
In node view of the new node, click the
Circuits
tab. Check to ensure that all circuits listed have a status of
DISCOVERED. If all circuits listed are not DISCOVERED, call the Cisco TAC at (800) 553-2447 to open
a Return Material Authorization (RMA).
Stop. You have completed this procedure.
NTP-G118 Replace the ANSI Shelf Plastic Lower Backplane
Cover
This procedure replaces the metal cover with the plastic cover located at the bottom
rear of the ONS 15454 ANSI shelf.
Purpose
Phillips screwdriver
Tools/Equipment
None
Prerequisite Procedures
As needed
Required/As Needed
Onsite
Onsite/Remote
None
Security Level
Procedure
Step 1
Use the Phillips screwdriver to unscrew the five retaining screws that hold the metal cover in place.
Step 2
Grasp the metal cover on each side.
Step 3
Gently pull the metal cover away from the backplane.
Step 4
Place the plastic cover against the shelf assembly and align the screw holes on the cover and the shelf assembly.
Maintaining the ONS 15454 M12 (ANSI and ETSI), ONS 15454 M2 and ONS 15454 M6 Shelf
29
Maintaining the ONS 15454 M12 (ANSI and ETSI), ONS 15454 M2 and ONS 15454 M6 Shelf
NTP-G118 Replace the ANSI Shelf Plastic Lower Backplane Cover
