Cisco ONS 15454 DWDM, Installation And Operation Manual

Page: 632 / 1218

11-44
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 11 Change DWDM Card Settings
DLP-G247 Change AIC-I Card Orderwire Settings
Step 5 Click Apply .
Step 6
Return to your originating procedure (NTP).
DLP-G247 Change AIC-I Card Orderwire Settings
Caution
When provisioning orderwire for ONS 15454s residing in a ring, do not provision a complete orderwire
loop. For example, a four-node ring typically has east and west ports provisioned at all four nodes.
However, to prevent orderwire loops, provision two orderwire ports (east and west) at all but one of the
ring nodes.
Tip
Before you begin, make a list of the ONS 15454 slots and ports that require orderwire communication.
Step 1
In node view, double-click the AIC-I card to display it in card view.
Step 2 Click the Provisioning > Local Orderwire tabs or the Provisioning > Express Orderwire tabs,
depending on the orderwire path that you want to change. Provisioning steps are the same for both types
of orderwire.
Step 3
If needed, adjust the transmit (Tx) and receive (Rx) dBm values by moving the slider to the right or left
for the headset type (four-wire or two-wire) that you will use. In general, you should not need to adjust
the dBm values.
Step 4
If you want to turn on the audible alert (buzzer) for the orderwire, check the Buzzer On check box.
Step 5
Click Apply .
Step 6 Return to your originating procedure (NTP).
Purpose This task changes orderwire settings on the AIC-I card.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher