Cisco ONS 15454 DWDM, Installation And Operation Manual

Page: 456 / 1218

7-20
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 7 Create Channels and Circuits
DLP-G110 Create a User Data Channel Circuit
• Port—If applicable, choose the source port.
Step 6
Click Next .
Step 7
In the Circuit Destination area, complete the following:
•
Node—Choose the destination node.
• Slot—Choose the destination slot.
•
Port—If applicable, choose the destination port.
Step 8 Click Finish .
Step 9
Return to your originating procedure (NTP).
DLP-G110 Create a User Data Channel Circuit
Step 1
In network view, click the Provisioning > Overhead Circuits tabs.
Step 2 Click Create .
Step 3
In the Overhead Circuit Creation dialog box, complete the following fields in the Circuit Attributes area:
• Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters
(including spaces).
•
Type—Choose either User Data-F1 or User Data D-4-D-12 from the drop-down list.
(User Data D-4-D-12 is not available if the ONS 15454 is provisioned for DWDM.)
Step 4
Click Next .
Step 5
In the Circuit Source area, complete the following:
• Node—Choose the source node.
•
Slot—Choose the source slot.
• Port—If applicable, choose the source port.
Step 6
Click Next .
Step 7
In the Circuit Destination area, complete the following:
•
Node—Choose the destination node.
• Slot—Choose the destination slot.
•
Port—If applicable, choose the destination port.
Purpose This task creates a UDC circuit on the ONS 15454. A UDC circuit allows
you to create a dedicated data channel between nodes.
Tools/Equipment OSCM, OSC-CSM, MXPP_MR_2.5G, or MXP_MR_2.5G must be
installed.
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher