![Cisco ONS 15454 DWDM Installation And Operation Manual Download Page 410](http://html.mh-extra.com/html/cisco/ons-15454-dwdm/ons-15454-dwdm_installation-and-operation-manual_63831410.webp)
5-72
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G238 Change OC-48/STM-16 Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards
Table 5-44
MXP_MR_2.5G and MXPP_MR_2.5G Muxponder Card Line SONET or SDH Tab Settings
Parameter
Description
Options
Port #
(Display only) Port number.
9 (trunk for MXP_MR_2.5G) or 9 and 10 (trunks for
MXPP_MR_2.5G)
Port Name
Provides the ability to assign the specified port a
name.
User-defined. Name can be up to 32 alphanumeric/
special characters. Blank by default.
See the
“DLP-G104 Assign a Name to a Port” task on
.
Admin State
Sets the port service state unless network
conditions prevent the change. For more
information about administrative states, see
Appendix C, “DWDM Administrative and
Service States.”
•
IS (ANSI) or Unlocked (ETSI)
•
IS,AINS (ANSI) or Unlocked,automaticInService
(ETSI)
•
OOS,DSBLD (ANSI) or Locked,disabled (ETSI)
•
OOS,MT (ANSI) or Locked,maintenance (ETSI)
Service State
Identifies the autonomously generated state that
gives the overall condition of the port. Service
states appear in the format: Primary
State-Primary State Qualifier, Secondary State.
For more information about service states, see
Appendix C, “DWDM Administrative and
Service States.”
•
IS-NR (ANSI) or Unlocked-enabled (ETSI)
•
OOS-AU,AINS (ANSI) or Unlocked-disabled,
automaticInService (ETSI)
•
OOS-MA,DSBLD (ANSI) or
Locked-enabled,disabled (ETSI)
•
OOS-MA,MT (ANSI) or
Locked-enabled,maintenance (ETSI)
SF BER
1
Sets the signal fail bit error rate.
•
1E-3
•
1E-4
•
1E-5
SD BER
1
Sets the signal degrade bit error rate.
•
1E-5
•
1E-6
•
1E-7
•
1E-8
•
1E-9
AINS Soak
Sets the automatic in-service soak period.
Double-click the time and use the up and down
arrows to change settings.
•
Duration of valid input signal, in hh.mm format,
after which the card becomes in service (IS)
automatically
•
0 to 48 hours, 15-minute increments
Type
The optical transport type.
•
SONET (ANSI)
•
SDH (ETSI)
Summary of Contents for ONS 15454 DWDM
Page 38: ...Figures xxxviii Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 ...
Page 54: ...Procedures liv Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 ...
Page 64: ... 64 Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 Chapter ...